Instructions Copyright 2011 Vmaxbitz.com Ltd
Daytona Nano Speedometer
Please read the instructions thoroughly and have a practice at setting the buttons before setting up properly, there are only two main instructions either hold down the button for 3 seconds or press and release the button.
To set up gauge.
1. Press button until the word set appears in the lower left of the screen
2. Hold down button for 3 seconds the word clo appears
3. Hold down button for 3 secondos until the first unit of time apeears – press and release button quickly to adjust first hours then minutes.
4. When you have the correct time set hold down button for 3 seconds and UNT will appear in the screen, press and release button quickly to switch between Miles and kilometres
5. Press and hold button for 3 seconds and you will see Auto this is the setting if you are using the vehicles own oem speed sensor, if you are using the provided speed sensor and magnet skip this setting.
6. Press and hold button for 3 seconds and CLR will appear this is where you put in the outside circumference of your tyre the easiest way to do this is to set the wheel with the tyre inflation valve at the 6 o clock position put a mark on the floor, rotate the wheel one full revolution until the valve is once again at the 6 o clock position mark the floor again, measure in millimetres and enter that into the clock as per the other settings above.
7. Press and hold the button for three seconds and the unit is now set up.
Any problems phone 021 745 9555.
